Security Window Film (12 mil.)

From: $39.99

Similar in make-up to our 8 mil. Security Film, the 12 mil. Security Window Film offers the highest protection against robbery attempts, household accident, wind damage, and even some outside explosion safety. Because the film is 1½ times thicker than the 8 mil, this gives it an added layer of resistance; resulting in an even harder film for burglars to get through and in some cases causing objects will simply bounce off the glass on impact. It’s also designed to hold the glass together, in the event of a breakage. The R07503 Security Film is a must have for the home safety conscious. Take a look at the excellent video below to see it in action! Our films are designed and constructed the same as the PET films discussed in this Discovery Channel Video:

Try a FREE Sample (Quantity 3)

SKU: PVS7503 Category: Tags: , ,


Test Standard Characteristic Result
16 CPSC 1201
Safety Glazing
Impact Resistance Designed to Pass
Category I & II
16 CPSC 1201
Safety Glazing
Weathering Meets Requirements of
Section 1201.4(e) 1(iv) & 2(iv)
ANSI Z97.1 Impact Resistance Designed to Pass
Unlimited Requirements
ANSI Z97.1 Weathering Designed to Meet Requirements
Of Section Z97.
BS 2606 Impact Resistance Designed to Pass
All Requirements
ASTM D3330-96
Peel Adhesion 5.5lbs/in Pre-Weathered
ASTM D1044-94 Surface Abrasion
Delta Haze <3%
ASTM D635-88 Rate of Burning Material Does Not Stay
Ignited Long Enough for Reading
GSA’s Method for Glazing Systems Subject to Air Blast Loading Bomb Blast Mitigation Designed to Perform to GSA
Hazard Level 3 Open Arena
Dade County
Small Missile Test
Wind Borne Debris Designed to Pass PA201, PA202 and PA203 with Anchoring
HPW-TP-0500.02 Ballistics .38 Special
On 3/4″ Glass
No Penetration-3shots
HPW-TP-0500.02 Ballistics 9mm
On 3/4″ Glass
No Penetration-3shots
HPW-TP-0500.02 Ballistics .38 Special
On 1/2″ Glass
No Penetration – 2 shots
Penetration – 3rd shot

All security films are installed on the interior surface of a window. The best method of installation is to remove the glass from the window frame, install the film, and reinstall the glass into the frame. The frame will act as an anchor to the film. If this is not possible, a bead of clear (or white, if preferred) silicone around the edge of the glass, about 24-48 hours after installation, is highly recommended. This will keep the glass and film firmly anchored in the frame if the glass is broken.

Additional information

Select Size

30" x 3ft, 30" x 7ft, 30" x 12ft, 30" x 18ft, 30" x 25ft, 60" x 3ft, 60" x 7ft, 60" x 12ft, 60" x 18ft, 60" x 25ft


There are no reviews yet.

Be the first to review “Security Window Film (12 mil.)”