Security Film
r07502securitywindowfilm8mil_1sledgehammer-breaking-glass

Security Window Film (8 mil.)

$34.99$299.99

A deterrent to would-be robbers, protection from the average household accident, and guards against wind borne debris.. these are just a few of the features you will receive when installing our Security Window Film (8 mil).

Designed to hold the glass together in the event that the window is broken or damaged, this film also contains a UV rejection rate of up to 99%. When installed correctly, the R07502 security film forces someone trying to break through to expend much more time and energy, just to penetrate it a little bit, that it is more likely they will retreat. In addition to the security, this film has the added benefit of protecting your house and family from everyday accidents; maybe a ball is accidentally thrown at a window, or a large glass door appears open and someone may run through it. Either way, with the added safety a severe injury is much less likely. For even higher protection, check out our 12 mil Security Window Film.

Our films are designed and constructed the same as the PET films discussed in this Discovery Channel Video

Test Standard Characteristic Result
16 CPSC 1201
Safety Glazing
Impact Resistance Designed to Pass
Category I & II
16 CPSC 1201
Safety Glazing
Weathering Meets Requirements of
Section 1201.4(e) 1(iv) & 2(iv)
ANSI Z97.1 Impact Resistance Designed to Pass
Unlimited Requirements
ANSI Z97.1 Weathering Designed to Meet Requirements
Of Section Z97.1.5.3.1
BS 2606 Impact Resistance Designed to Pass
All Requirements
ASTM D3330-96
ASTM G26
Peel Adhesion 5.5lbs/in Pre-Weathered
ASTM D1044-94 Surface Abrasion
Resistance
Delta Haze <3%
ASTM D635-88 Rate of Burning Material Does Not Stay
Ignited Long Enough for Reading
GSA’s Method for Glazing Systems Subject to Air Blast Loading Bomb Blast Mitigation Designed to Perform to GSA
Hazard Level 3 Open Arena
Dade County
Small Missile Test
Wind Borne Debris Designed to Pass PA201, PA202 and PA203 with Anchoring

All security films are installed on the interior surface of a window. The best method of installation is to remove the glass from the window frame, install the film, and reinstall the glass into the frame. The frame will act as an anchor to the film. If this is not possible, a bead of clear (or white, if preferred) silicone around the edge of the glass, about 24-48 hours after installation, is highly recommended. This will keep the glass and film firmly anchored in the frame if the glass is broken.

Try a FREE Sample (Quantity 3)

Warning

Deleting file, please wait...

Clear
Additional Information
Select Size

30″ x 3ft, 30″ x 7ft, 30″ x 12ft, 30″ x 18ft, 30″ x 25ft, 60″ x 3ft, 60″ x 7ft, 60″ x 12ft, 60″ x 18ft, 60″ x 25ft

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Security Window Film (8 mil.)”

Your email address will not be published. Required fields are marked *